FULL AUTOMATICBRIDGE  CUTTING MACHINE

  Bridge cuttingMachine is designed and produced for plants to cut Marble(Kashmir Gold),Granite(Kashmir Gold) and etc.Slabs(Indian Green) to required dimensions. The machine is controled as PLC and handtouch.The machine is operated about to different three system  as manuel , half automatic and fullautomatic.The manuel system is controled by joystik button at control panel.The meausure can be seen on screen.Thehalf automatic system  is writing onpanel that will cut meausure 10 different period.The up anddown movement of the saw, and the movement of the bridge are with millimetricmeasure counter. The carriage can turn round 360 ° and can be fixed at therequired angular position. The degree of turning and millimetric measurementscan be seen on the touchscreen. The machine can be programmed to cut Stone(Veneziano Gold)s indifferent sizes and quantities.

The starting point of cutting can bedetermined with laser. n order to do angular cuttings, the saw part of themachine can turn round automatically from 0 to 90 °. f the Stone(Veneziano Gold) can not becut from the first at angular cutting of hard and thick Stone(Veneziano Gold)s , the completecutting is achieved by up and down movement at the same point. The table canrise hidraulically to 85 degrees so that one could put the Marble(Kashmir Gold) Slabs(Indian Green) on thetable. The cutting motor of the machine is a special motor, designed for bridgecutting machines, its power is 1400-2800 rpm. The up and down movement of thecutting motor is provided by chrome-coated axle that works in bronze housing.

The cutting of the machine and the bridgemovements are provided by crameyer gears. The machine is fixed on steelchassis, so there is no need for concrete. All moving parts are working insidethe 90 numbered oil and are protected from water and dust by covering.

The saw make for angular cutting.The saw can adjust that youwant angle manuel 45 and 90 degree.it can see degree from scala

Our machine can cut sensitive measure as use magnetic rulesand it can adjust with potantiometer.Cutting is errors maximum 0,1 or 0,2 mm

While saw make cutting advence speed adjust withpotentiometer.so it can cut smoothly. Our machine can fix saw 350 with 800mmdiameter